In tight binding, the rope is almost always folded in half. Compared to a single rope, tying it together is safer and less likely to get stuck in the skin.
Of course, it is very troublesome to fold the SM in half every time, so you can tie a knot at the center of the rope as shown in the picture, and then untie it when using it.

Usually, ropes are tied up for preservation. Although there are also ways to save the rope by beautifully rolling it up, it takes a lot of time to untie it during use, so just save it as shown in the picture.

1. Put your hands together, and to prevent the rope from becoming loose, keep your wrists tightly together.

2.Wrap 2-3 circles of rope around the wrist that is tied together.

3. Tie the wrapped rope together.

4. Thread the rope through the inner side of the winding section and tie it again. This can prevent the rope from knotting and must pass through the inside. This completes the basic restraint of the wrist.

5.If you want to increase the sense of restraint, you can thread the remaining rope through the middle of your wrist.

6. Wrap the rope again to complete it. This method can enhance the sense of restraint, and pulling the rope can also make the wrist part tighter. After fixing the rope once, it can be completed.

1. Bring your feet together like a wrist.

2. Wrap the rope 2-3 times.

3. Tie the wrapped ropes together.

4. Thread the rope through the inner side of the wrapped rope and tie it together to prevent knots.

5. Complete

1. Grasp the ankle with your hands.

2. Wrap the wrist and ankle tightly together with a rope 2-3 times.

3. Tie them together.

4. Thread the rope through the inner side of the winding rope and tie it together to prevent knots.

5. Complete